Perlindungan Sensor Suhu Cu/Ni dengan Nitroselulosa
DOI:
https://doi.org/10.30599/jipfri.v8i2.3820Keywords:
Thickness of the NC protective layer, absolute sensitivity, activation energyAbstract
Coating of Cu/Ni with nitrocellulose (NC) has been carried out with the aim of determining the effect of using NC as a protective film on the sensitivity and activation energy of the sensor. The samples used were Cu/Ni and Cu/Ni/Cu where the NC coating on Cu/Ni was carried out using a spray method with a pressure of 1.2 Mpa. Both sensor samples were used to measure the temperature of liquid nitrogen (liquid N2) which was varied from -160C - 0C. In addition to temperature, voltage and current were also measured. The sensitivity value was obtained from the slope of the resistance curve against temperature, while the activation energy was obtained from the slope of the logarithm of conductivity against one per absolute temperature. From the sensitivity test, it is known that both sensors have a tendency to be more sensitive when the temperature is lowered, but the presence of the NC layer causes a decrease in sensitivity of up to 18.9%, namely from 3.95 /C to 3.18 /C at a temperature of -160C following the equation S(T)=0.10e-0.012T. The use of NC protective layer can also increase the activation energy by 1.3%, namely from (4.29 0.01)x10-9 eV to (4.35 0.01)x10-9 eV. These results can be used as a consideration for temperature sensor manufacturers that the use of NC protective layer is important but can reduce sensor sensitivity.
Downloads
References
Aljubouri, A. A., Faisal, A. D., & Khalef, W. K. (2018). Fabrication of temperature sensor based on copper oxide nanowires grown on titanium coated glass substrate. Materials Science-Poland, 36(3), 460-468. https://doi.org/10.2478/msp-2018-0051
Caldona, E. B., Wipf, D. O., & Smith Jr., D. W. (2021). Characterization of a tetrafunctional epoxy-amine coating for corrosion protection of mild steel. Progress in Organic Coatings, 151, 106045. https://doi.org/10.1016/j.porgcoat.2020.106045
Giametta, F., Perone, C., Di Iorio, M., Rusco, G., Catalano, P., & Iaffaldano, N. (2021). A New Freezing Box for the Managing of Semen Cryopreservation Process. Chemical Engineering Transactions, 87, 265-270. https://doi.org/10.3303/CET2187045
Haris, C.T., and Lu, T.M. (2021). A PtNiGe resistance thermometer for cryogenic applications, Rev. Sci. Instrum (92), 1-5.
Hossain, N., Rimon, M.I.H., Mimona, M.A., Mobarak, M.H. (2024). Prospects and Challenges of Sensor Materials: A Comprehensive Review. e-Prime - Advances in Electrical Engineering Electronics and Energy, 7(19):100496. https://doi.org/10.1016/j.prime.2024.100496
Ihsan, M., Toifur, M., Khusnani, A. (2021). Effect of Temperature of Electrolyte Solution On Cu/Ni Layer On Low-Temperature Voltage Range Measurement Performance. Indonesian Journal of Science and Education, 5(2), 106-110. https://doi.org/10.31002/ijose.v5i2.3611
Jain, R., & Gawre, S. K. (2022, February). Monitoring and Control of COVID Vaccine Storage Temperature Using IoT and Machine Learning. In 2022 IEEE International Students' Conference on Electrical, Electronics and Computer Science (SCEECS) (pp. 1-6). IEEE. https://doi.org/10.1109/SCEECS54111.2022.9740740
Jia, J., Liu, W., Zhu, H., Show, L.. Li, B., Shi, Z., Cui, Q., Xu, C. (2023). Temperature Sensors Based on Negative Temperature Coefficient of ZnO Thin Films. IEEE Transactions on Electron Devices, 99, 1-7. https://doi.org/10.1109/TED.2023.3314400
Kim, C. H., Lee, S. Y., & Park, S. J. (2022). Positive/negative temperature coefficient behaviors of electron beam-irradiated carbon blacks-loaded polyethylene nanocomposites. ACS omega, 7(51), 47933-47940. https://doi.org/10.1021/acsomega.2c05806
Liu, Z., Huo, P., Yan, Y., Shi, C., Kong, F., Cao, S., ... & Yao, J. (2024). Design of a Negative Temperature Coefficient Temperature Measurement System Based on a Resistance Ratio Model. Sensors, 24(9), 2780. https://doi.org/10.3390/s24092780
Lomov, S. V., Akmanov, I. S., Liu, Q., Wu, Q., & Abaimov, S. G. (2023). Negative Temperature Coefficient of Resistance in Aligned CNT Networks: Influence of the Underlying Phenomena. Polymers, 15(3), 678. https://doi.org/10.3390/polym15030678
Mizunami, T. (2000, November). A high-sensitivity cryogenic fiber-grating temperature sensor. In Fourteenth International Conference on Optical Fiber Sensors (Vol. 4185, pp. 175-178). SPIE. https://doi.org/10.1117/12.2302180
Nam, V.B., Lee, D. (2021). Evaluation of Ni-Based Flexible Resistance Temperature Detectors Fabricated by Laser Digital Pattering. Nanomaterials, 11(576),1–13. https://doi.org/10.3390/nano11030576
Sarkar, S. (2018). Platinum RTD sensor based multi-channel high-precision temperature measurement system for temperature range− 100 C to+ 100 C using single quartic function. Cogent Engineering, 5(1), 1558687. https://doi.org/10.1080/23311916.2018.1558687
Singgih, S., Toifur, M. (2020). Pengukuran Nilai Resistivitas Plat Tipis Cu-Ni Hasil Elektroplating Variasi Konsentrasi Larutan dan Jarak Katoda sebagai Sensor Suhu Rendah Berbasis Resistance Temperature Detector (RTD). Prosiding Seminar Nasional Fisika dan Pendidikan Fisika, June (2020).
Toifur, M., Khansa, M. L., Okimustava, O., Khusnani, A., & Ridwan, R. (2020). The Effect of Deposition Time on the Voltage Range and Sensitivity of Cu/Ni as Low-Temperature Sensor Resulted from Electroplating Assisted by a Transverse Magnetic Field. Key Engineering Materials, 855, 185-190. https://doi.org/10.4028/www.scientific.net/KEM.855.185
Toifur, M., Khusnani, A., Okimustava. (2019). Effect of Mass Fraction of Ni in Solution on the Microstructure and Sensitivity of Cu/Ni Film as Low-Temperature Sensor. Universal Journal of Electrical and Electronic Engineering, 6(5B), 76 – 83.
Vincent, T. A., Maddar, F. M., Chao, S., Guk, E., Sansom, J. E., Gulsoy, B., ... & Marco, J. (2024). A compatibility study of protective coatings for temperature sensor integration into sodium-ion battery cells. Journal of Physics: Energy, 6(2), 025002. https://doi.org/10.1088/2515-7655/ad1e38
Wang, F., Xu, J., Xu, Y., Jiang, L., & Ma, G. (2020). A comparative investigation on cathodic protections of three sacrificial anodes on chloride-contaminated reinforced concrete. Construction and Building Materials, 246, 118476. https://doi.org/10.1016/j.conbuildmat.2020.118476
Xiao, X. (2022). Facile Fabrication Of Flexible Sustainable Light Energy Harvester for Selfpowered Sensor System In Food Monitoring, Sensors Int. 3,100133. https://doi.org/10.1016/j.sintl.2021.100133
Downloads
Published
Issue
Section
License
Copyright (c) 2024 Miftahus Surur, Moh. Toifur, Okimustava Okimustava, Siti Zahra Helmania Putri
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
